STANDARD OF DEPTH OF CUT EXTERNAL (RADIAL INFEED)

UNJ

Pitch (thresd /inch )	Total Cutting Depth	Number of Passes											Insert Type
Pitch (thresd /inch )	Total Cutting Depth	1	2	3	4	5	6	7	8	9	10	11	Insert Type
32	0.46	0.16	0.14	0.10	0.06								MMT16ER320UNJ
28	0.52	0.16	0.12	0.09	0.09	0.06							16ER280UNJ
24	0.61	0.17	0.14	0.14	0.10	0.06							16ER240UNJ
20	0.73	0.19	0.16	0.13	0.10	0.09	0.06						16ER200UNJ
18	0.81	0.23	0.18	0.14	0.10	0.10	0.06						16ER180UNJ
16	0.92	0.26	0.21	0.14	0.12	0.10	0.09						16ER160UNJ
14	1.05	0.26	0.23	0.17	0.12	0.11	0.10	0.06					16ER140UNJ
12	1.22	0.28	0.27	0.20	0.17	0.13	0.11	0.06					16ER120UNJ
10	1.47	0.30	0.29	0.21	0.15	0.13	0.12	0.11	0.10	0.06			16ER100UNJ
8	1.83	0.31	0.30	0.23	0.18	0.15	0.14	0.13	0.12	0.11	0.10	0.06	16ER080UNJ

(Note)

Set the finishing allowance on a diameter at approx. 0.1mm when using a full form insert.
Please note the cutting depth and the number of passes when a nose radius of a partial form insert or of an internal threading insert is small to prevent damage to the insert nose.
Please set the cutting depth sufficiently deep enough on materials such as hardened steel or austenitic stainless steel to help prevent premature wear and chipping caused by the outer layer of the material.