 BACK |
- Product Information
- Products Guide
- Drilling
- Indexable Type
- TAW Drills
TAW DRILLS
HONE WIDTH
If an insert with honing other than standard is needed, please order using the symbols below.
| Honing Type | Hone Width (mm) |
|---|---|
| F | 0 |
| G | 0.02─0.05 |
| H | 0.05─0.10 |
| -(Standard) | 0.10─0.15 |
| K | 0.15─0.20 |
| S | 0.20─0.25 |
| M | 0.25─0.30 |
NOTES ON USE
INSERT INSTALLATION
- Loosen the clamp screw to install the insert.
- Correctly mesh the insert and the holder serrations, then slide the insert to the bottom of the slot.
- Fasten the clamp screw using the torque wrench provided while holding the insert lightly as shown. (Figure 1)
- Check there is no gap between the bottom of the insert and holder. (Figure 2)
INSERT REPLACEMENT
- Thouroughly clean the serrations of the holder before installing a new insert.
Remove heavy dirt in the holder serrations by using the cleaning plate provided.
